Release the clips securing it’s harness to the air box. Disconnect the electrical connector at the mass airflow sensor (MAF). Supercharger Installation Instructions 5. Using a 10mm socket, remove the two bolts securing the metal tube to the front of the valve cover.
In addition, you should save the parts that will not get reused in case you ever have reason to convert the engine back to stock. It is recommended that you make space for those that you will reuse, and a separate space for those that you will not reinstall. During this installation process, you will reuse some parts or hardware and not reinstall others. WARNING:91-octane gasoline (or higher) is required when running a supercharger. Use your discretion- if you are not a competent mechanic, do not attempt this installation. SPECIAL NOTE: Moss Motors Supercharger Systems are designed to be installed by individuals with good mechanical skills and with the proper tools. Use a pair of needle nose pliers to release the clamp securing the PCV hose to the valve cover, connected near the oil filler cap. NOTE: Cannot be installed with any strut tower brace.
MIATA POWERCARD SERIAL
Be certain to do this now because once your supercharger is installed, it may be difficult to see the serial number. Write down all of the numbers which appear on that label in the appropriate space on the warranty card.
MIATA POWERCARD SERIAL NUMBER
Teflon tape), heat gun or lighter, #29 drill bit, electric drill, ruler or straight-edge, paper clip, utility knife, and a timing light.ĪTTENTION SUPERCHARGER INSTALLER! Before proceeding with the installation, it is important to know that to validate the 2 year, 100K warranty on your new supercharger, you must completely fill out the Moss Motors warranty card that comes in every kit, including the serial number which is on a small white ‘bar code’ label on the body of the supercharger. TOOLS REQUIRED: 8mm, 10mm, 12mm, 14mm (deep), 16mm, 17mm, and 7/16” sockets, (2)12mm, a 14mm, 15mm, 17mm, 22mm (or adjustable wrench), a 1/2", and 7/8” combination wrenches, multipurpose pliers, needle nose pliers, wire cutters, wire crimpers/strippers, (2) needle nose locking pliers (Vise Grips), hose cutter, small and medium flat blade screwdrivers, #2 and #3 phillips screwdrivers, dead-blow hammer, torque wrench, thread sealing tape (i.e. NOTE: If your car has Cruise Control you will need kit #999-827. We suggest that as you proceed through the installation, you should read a few steps ahead in the instructions so you are certain to catch all notes and warnings. D-453-8 999-845 w/ power steering, AC 999-846 w/ power steering, w/o AC 999-847 w/o power steering, w/AC READ THESE INSTRUCTIONS THOROUGHLY! Follow the instructions STEP-BY-STEP, and your installation will be trouble free. Miata MP62 Supercharger System Installation Instructions FOR 1994-97 Miata CARB E.O.
0 kommentar(er)
